| Basic Performance | |
|---|---|
| Speed | 180 m/min |
| Bending Radius | 10 x Ø |
| Acceleration | 2,0 m/sec2 |
| Cycles | 200.000 |
| Torsion | ±30°/1000 mm |
| Pulling | ≤ 20 N/mm2 |
Cables conforming to LENZE® standard, designed for power and control actuator drive systems. Highly flexible conductors, PVC-resistant PVC or PUR outer sheath provide a suitable product for a wide range of high-performance,ranging from fixed applications to high speed drag-chains. High dynamic parameters, reduced bending radii, chemical resistance to oils and industrial fluids. The PUR sheath version is also suitable for low temperature applications. Low dielectric capacity, shielded high-tinned copper braid for high EMC protection and a Lenze® standard construction. The cables are UL / CSA and EAC approved and follow the DESINA standard.
Note: The reported Lenze codes are trademarks of Lenze AG and are for comparative purposes only. Desina® is a registered trademark of the German machine tool builders (VDW). The article codes refer to existing MotionCables products. The drawings are not on a scale and do not represent a detailed picture of the products to which they refer.
 |
Operating Voltage | 0.6 / 1.0 kV |
 |
Temperature | Fixed -30 °C / +90 °C Dynamic -15 °C / +30 °C |
 |
Dielectric Strength | 4.0 kV acc.to EN 50395 Part 6 - 7 |
 |
Insulation Resistance | ≥ 1 GΩ x km acc.to EN 50395 Part 8 |
 |
Electrical Resistance | IEC 60228 Cl.5 EN 50395 Part. 5 |
 |
||
details
Complete datasheet with construction available upon demand |
 |
Oil Resistant (0-II) |
|---|---|
| UL Oil Res. I | |
 |
Flame Resistant |
| IEC 60332-1-2; UL VW1; UL FT 1 |
 |
 |
 |
 |
| CYCLES | BENDING RAD. | SPEED | ACCELL. |
|---|---|---|---|
| 200.000 | 10 x Ø | 180 m/min | 2,0 m/sec2 |
Similar Products - DRIVEConn® MT - SERVO
